B&G H2000 Pilot *DISCONTINUED* - Manual (Page 30)

HB-0844-04
2-11
Note
The NAV key may be configured to show waypoint information in either Great
Circle or Rhumb modes. Refer to section 2.5.3 for further details.
2.1.9 Remote Button Operation
Each FFD may be provided with an optional Remote Button to allow basic
control of the associated FFD from a remote position. The Remote Button
has two Functions: Page Selection and Fast Reset.
Page Selection is achieved by successive pressing of the Remote Push-
Button. When the button is pressed each of the four user defined pages
followed by the first page of the factory set Speed/Depth, Navigate and Wind
pages are displayed in a fixed order.
When any one of the trip functions is selected at the associated FFD,
pressing and holding down the Remote Push-Button for two seconds will
change the display to show RESET flashing, or if TIMER is selected START
10 flashing. Pressing the Remote Button again will Reset that function, or in
the case of TIMER start the countdown. After a reset the display will revert to
normal page set-up automatically.
2.2 20/20 DISPLAY
The 20/20 is a fully programmable, single function display, incorporating
large digits, which may be installed virtually anywhere in the yacht.
Control of the 20/20 Display may be achieved via any FFD or from an
optional Remote Button, see Part 5 - Options.
2.3 SUPER HALCYON 3 AND HALCYON 2000 COMPASS
The Super Halcyon 3 and Halcyon 2000 Compasses are high performance
electronic transmitting compasses which interface with your Hydra 2000
System. Heading and direction information may be selected for display on
any of the FFDs or on a Halcyon Display. Additionally, analogue compass
card displays may also be added.
Software incorporated within the compass allows the unit to learn the
magnetic fields in the vessel that may cause deviation errors. These errors
can be reduced to an insignificant level by following the Calibration
procedure described in Part 3.