B&G H2000 Pilot *DISCONTINUED* - Manual (Page 132)

HB-0844-04
5-15
5.7.3 Function Selection - Remote Push-Button
If a remote push-button is connected to a 40/40 display any one of the 14
pre-set functions may be selected by pressing and holding down the
associated button. The display will then cycle through the functions. When
the required function is displayed, release the button.
If the button is held down too long and the required function is missed, press
and hold down the button again. The display will then cycle through the
functions in reverse order. When the required function is displayed, release
the button.
5.7.4
Function Selection - FFD
An alternative to using a dedicated remote push-button, is to control the
40/40 using any one of the standard FFDs on the system. Any 40/40 can be
controlled from any FFD.
To change the function shown on a 40/40 using an FFD, proceed as follows:
(1) At the FFD, press and hold down the Page Key for at least 3
seconds. The FFD display will change to show the function
displayed on the 40/40 together with the display number. The
selected display will start to flash.
(2) Using the Scroll Down Key cycle through the 40/40 numbers
and select the required display number.
(3) Using the Scroll Up Key cycle through the 14 pre-set functions
until the required function is displayed on the FFD. Release the
Scroll Up Key.
(4) If the function is missed, press and hold down the Scroll Up
Key and the functions will cycle through in reverse order. Release
the Scroll Up Key when the required function is displayed.
(5) Press the Page Key. The FFD will now return to normal
operation and the 40/40 will display the selected function.