Great Plains PFC2000 Operator Manual - Manual (Page 52)

50
407-158M 03/28/2007
Planter Assembly Installation
These instructions are only needed if the lighting exten-
sion cables, CANbus extension cables and gauge line
were not factory-installed on the planter. This can be the case if the tank cart was ordered sepa-
rately from or later than the planter. If so, these assem-
blies are provided in a carton with the tank cart.
Planter Control Cable Extension
Refer to Figure 25 and Figure 26
1. On the right wing of the planter, locate the last
WSMB
(Working Set MemBer module). One
side of the harness at this module has a CAN
terminator plugged into the cable.
2. Lift the latch . Unplug/save the terminator .
3. Select the:
467980144 40’ EXTENSION HARNESS
467980361 6’ REAR HITCH HARNESS
800-082C CABLE TIE .31X21.5 6DIA 120LB
4. Connect the plug end of the hitch harness into
the receptacle end of the extension harness .
5. Connect the plug end of the extension harness
to the harness receptacle
where the CAN termi-
nator was just removed.
6. Route the extension/hitch harness toward the cen-
ter of the planter. Near the center follow right fertil-
izer manifold feed line down to the hitch, to ensure
safe placement and correct slack at the wing pivot.
Loosely secure with cable ties
.
Note: Do not consume all the ties at this step. They are
also needed for the lighting and gauge lines.
7. If the hitch connector can touch the ground, coil
the excess under a tie near the hitch. Verify that
the cart’s control cable has enough reach to make
the connection and maintain it during tight turns.
8. Secure cable ties.
9. Locate the control cable harness at the Frame
Control Module of the tank cart. This harness has
a CAN receptacle identical to that on the planter.
10. Plug the saved CAN terminator into that cable
receptacle.
Callout Quantity Part No. Part Description Comment
20 800-082C CABLE TIE .31X21.5 6DIA 120LB New parts
1 823-270C PFC INTELLIAG BOOM/PUMP CONTRL
Parent Kit (only planter-mounted
components listed)
1 467980126 CAN TERMINATOR Moved from WSMB on planter
1 467980144 40’ EXTENSION HARNESS New part (DICKEY-john p/n)
1 467980361 6’ REAR HITCH HARNESS New part (DICKEY-john p/n)
11
12
13
14
Figure 25
Right Wing, Final WSMB
26157
1
2
12
1
1
12
3 12
13
14
11
14
13
13
3
Figure 26
Termination, Final WSMB
26158
26159
1
2
3
12
11
12