Great Plains YP1625 Operator Manual User Manual
Page 3

07/09/2009
401-226M
©
Copyright 2005, 2006, 2007, 2008. All rights Reserved.
Great Plains Manufacturing, Inc. provides this publication “as is” without warranty of any kind, either expressed or implied. While every precaution has been taken in the preparation
of this manual, Great Plains Manufacturing, Inc. assumes no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the use of the infor-
mation contained herein. Great Plains Manufacturing, Inc. reserves the right to revise and improve its products as it sees fit. This publication describes the state of this product at
the time of its publication, and may not reflect the product in the future.
Great Plains Manufacturing, Incorporated Trademarks
The following are trademarks of Great Plains Mfg., Inc.: Application Systems, Ausherman, Land Pride, Great Plains
All other brands and product names are trademarks or registered trademarks of their respective holders.
Printed in the United States of America.
Table of Contents
Great Plains Manufacturing, Inc.
Important Safety Information .................................. 1
Introduction ............................................................ 10
Description of Unit .................................................... 10
Document Family ..................................................... 10
Intended Usage .................................................... 10
Definitions............................................................. 10
Owner Assistance .................................................... 11
Product Support ................................................... 11
Preparation and Setup ........................................... 12
Pre-Start Checklist ................................................... 12
Protecting Hydraulic Motor Seals ............................. 12
Hydraulic Hose Hookup............................................ 12
Hitching Tractor to Planter........................................ 13
3-Point Hitch ......................................................... 13
Hydraulic Tongue Hitch ........................................ 13
Either Hitch ........................................................... 14
Hydraulic Charge and Bleed .................................... 15
Leveling Frame Side-to-Side.................................... 15
Wing Alignment ........................................................ 17
Optional Monitor Mounting Plate .............................. 18
Operating Instructions........................................... 19
Pre-Start Checklist ................................................... 19
Folding the Planter ................................................... 20
Unfolding the Planter................................................ 22
Changing the Seed Box or Hopper .......................... 23
Using Auxiliary Hydraulic Circuit........................... 24
Pre-Usage Checklist................................................. 25
Transporting ............................................................. 27
Field Operation......................................................... 28
Seed Hopper Sensor ............................................ 28
Monitor Operation................................................. 29
Electric Clutch Operation.......................................... 29
Electric Clutch Lockup .......................................... 30
Marker Operation ..................................................... 31
Airbox Operation ...................................................... 32
Fan Operation ...................................................... 32
Y-Tubes ................................................................ 32
Airbox Troubleshooting......................................... 33
Fertilizer Tanks (Option) ...........................................34
Parking......................................................................35
Storage .....................................................................36
Adjustments ............................................................37
Planting Rate ............................................................38
Drive Speed Range Sprockets..............................38
Transmission Sprockets........................................38
Contact Wheel Drive .............................................39
Checking Singulated Planting Rate ..........................40
Seed rate charts....................................................40
Marker Adjustments ..................................................41
Dual Marker Speed Adjustment ............................41
Marker Extension ..................................................41
Marker Disk Adjustment ........................................42
Hydraulic Drive Height Switch...................................42
Setting Fertilizer Rate ...............................................43
Hypro Pump ..........................................................43
Ground Drive Pump ..............................................44
Fan Adjustments .......................................................44
Row Implement Adjustments ....................................45
Frame-Mounted Row Accessories ........................45
Terra-Tine™ Adjustment ...................................45
Frame-Mounted Coulters ..................................46
Vantage I Fertilizer ............................................46
25 Series Row-Unit Adjustments ..........................47
Row-Unit Down Pressure ..................................48
Row Unit Lock-Up .............................................49
Unit-Mount Cleaner Adjustments ......................50
Unit-Mounted Coulter Adjustments ...................51
Row-Unit Planting Depth ...................................52
Side Gauge Wheel Adjustments .......................52
Adjusting Gauge Wheel Scrapers .....................53
Meter Exchange and Adjustments ........................54
Meter Removal ..................................................54
Singulator Plus™ Meter Wheel Replacement.......56
Meter Installation...................................................58
Finger Meter Adjustments .....................................59
Finger Meter Brush Adjustment ........................59
Finger Meter Inserts ..........................................60
Seed Firmer Adjustments......................................61