SARGENT Profile Series v.G1.5 Cylindrical Locks - Manual (Page 13)

11
A7854B • 800-810-WIRE (9473) • www.sargentlock.com
Profile Series v.G1.5 Cylindrical Lock
05/06/09
A7854:B
Copyright
©
2009,
Sargen
t
Manufacturing
Company
,an
A
S
S
A
AB
LO
Y
G
roup
company
.All
right
s
reser
ved
.
Reproduction
in
whole
or
in
par
t
without
the
express
writ
ten
permission
of
S
AR
G
EN
T
Manufacturing
is
prohibited
.
Installation
1. ElectroLynx ® System Wiring Instructions (refer to Fig. 1 and Fig.3)
a. Look for the mating part on ASSA ABLOY doors & frames. Then plug in all connectors as shown in Fig. 3
during product installation
b. Hard wire hard power and/or remote unlock (REX), as shown
2. Non-ElectroLynx ® System Wiring Instructions (refer to Fig. 1 and Fig.3)
a. Cut the 8-pin connector off the Remote Power/Unlock harness and hard wire to non-ElectroLynx ® door
harness. Remote power requires three conductors and remote unlock requires two conductors.
b. Hard wire door harness to power transfer device
c. Hard wire hard power and/or remote unlock (REX), as shown
6.10.E–Hard Power and Remote Unlock (91-)