Tweco 550i Transmig User Manual
350i operating manual, Transmig, Multi process welding inverter
This manual is related to the following products:
Table of contents
Document Outline
- 0-5143-CCr
- SECTION 1:ARC WELDING SAFETY INSTRUCTIONS AND WARNINGS
- SECTION 2:INTRODUCTION
- SECTION 3:INSTALLATION, OPERATION AND SETUP
- 3.01 Environment
- 3.02 Location
- 3.03 Ventilation
- 3.04 Mains Supply Voltage Requirements
- 3.05 Electromagnetic Compatibility
- 3.06 Transmig 350i, 450i, 550i Power Source Controls, Indicators and Features
- 3.07 Shielding Gas Regulator Operating Instructions
- 3.08 Setup for MIG (GMAW) Welding with Gas Shielded Mig Wire
- 3.09 Setup for MIG (GMAW) Welding with Gasless Mig Wire
- 3.10 Setup for TIG (GTAW) Welding With Gas Shielding
- 3.10 Setup for STICK (MMAW) Welding
- 3.11 Setup for GOUGING (Transmig 550i only)
- SECTION 4:BASIC WELDING GUIDE
- SECTION 5:POWER SOURCE PROBLEMS AND ROUTINE SERVICE REQUIREMENTS
- SECTION 6:KEY SPARE PARTS
- SECTION 7:Volt/ampERE curves
- SECTION 8: CIRCUIT DIAGRAM
- CIGWELD - LIMITED WARRANTY TERMS
- TERMS OF WARRANTY – JULY 2011
- WARRANTY SCHEDULE – JULY 2011
- GLOBAL CUSTOMER SERVICE CONTACT INFORMATION
- SECTION 1: ARC WELDING SAFETY INSTRUCTIONS AND WARNINGS
- SECTION 2: INTRODUCTION
- SECTION 3: INSTALLATION, OPERATION AND SETUP
- 3.01 Environment
- 3.02 Location
- 3.03 Ventilation
- 3.04 Mains Supply Voltage Requirements
- 3.05 Electromagnetic Compatibility
- 3.06 Transmig 175i Power Source Controls, Indicators and Features
- 3.14 Shielding Gas Regulator Operating Instructions
- 3.15 Setup for MIG (GMAW) Welding with Gas Shielded Mig Wire
- 3.17 Setup for TIG (GTAW) Welding
- 3.18 Setup for Manual Arc (MMAW) Welding
- SECTION 4: BASIC WELDING GUIDE
- SECTION 5: POWER SOURCE PROBLEMS AND ROUTINE SERVICE REQUIREMENTS
- CIGWELD - LIMITED WARRANTY TERMS
- TERMS OF WARRANTY - JULY 2010
- WARRANTY SCHEDULE - JULY 2010
- GLOBAL CUSTOMER SERVICE CONTACT INFORMATION