Tweco 400 MSTP Arcmaster - Manual (Page 63)

57
Description Possible Cause Remedy
9 Poor weld finish. Inadequate shielding gas. Increase gas flow or check gas line
for gas flow problems.
10 Arc flutters during
TIG welding.
A Tungsten electrode is too large for
the welding current.
A Select the right size electrode.
Refer to Basic TIG Welding guide.
B Absence of oxides in the
weld pool.
B Refer Basic TIG Welding Guide for
ways to reduce arc flutter.
11 Welding arc cannot be
established.
A Work clamp is not connected to the
work piece or the work/torch leads
are not connected to the right
welding terminals.
A Connect the work clamp to the work
piece or connect the work/torch
leads to the right welding terminals.
B Torch lead is disconnected. B Connect it to the ‘ −‘ terminal.
C Gas flow incorrectly set, cylinder
empty or the torch valve is OFF.
C Select the right flow rate, change
cylinders or turn torch valve ON.
12 Arc start is not smooth. A Tungsten electrode is too large for
the welding current.
A Select the right size electrode.
Refer to Basic TIG Welding Guide.
B The wrong electrode is being used
for the welding job.
B Select the right electrode type.
Refer to Basic TIG Welding Guide.
C Gas flow rate is too high. C Select the correct rate for
the welding job.
Refer to Basic TIG Welding Guide.
D Incorrect shielding gas is
being used.
D Select the right shielding gas.
Refer to Basic TIG Welding Guide.
E Poor work clamp connection
to work piece.
E Improve connection to
work piece.