Tweco 300 XT Ultra-Cut Plasma Cutting System - Manual (Page 184)

ULTRA-CUT 300 XT
�78 PPENDIX Manual 0�5�7�
613 USB Log File Creation Fault
When updating the CCM, DMC and DPC programs from a flash drive, a log file called CCM_LOG.TXT is cre�
ated on the flash which reports on the results of the update including any problems. If that log file can’t be
created you get 613. This may be a problem with the flash drive having too many other files on it or a problem
with its format that may not be compatible with the CCM.
1. Try putting the update files on a different, preferably empty, flash drive.
�. Or save all the flash drive files in another place on your computer, then delete all the files on the flash drive.
Now copy onto the flash drive only the files required for program updates.
3. If the above doesn’t work, making sure you still have copies of the files, format your flash drive which erases
everything on it. Now load only the files required for program update.
614 No USF File
The file VTCCMFW.USF is required on the flash drive along with the program files when performing a program
update. If it’s either missing or corrupted the display will show b61�. The “b” indicates the fault is generated
by the Bootloader program rather than the normal application program code. Note that each new revision of
the program files is supplied with a new VTCCMFW.USF. Even though the name is the same it requires the
new version of this file that is supplied with the application code.
1. Install the correct VTCCMFW.USF on the flash drive.
�. If you already have the correct version of VTCCMFW.USF perhaps the flash drive is the problem. Follow
the instructions for code 613.
615-617 No Update File for CCM, DPC or DMC found
Program files for the CCM, DMC & DPC may be updated through the plasma supply’s USB port. The GCM�010
is updated by other means. For a unit with GCM �010 the CCM may still be updated using the USB. Program
update files are in the format Cx_x_0.S (CCM); Mx_x_0.S (DMC) and Px_x_0.S (DPC).
If the Bootloader finds there are 3 devices, CCM, DMC & DPC on the CNBUS but the flash drive doesn’t have
all 3 update files it will go ahead and update those it has but will show a code indicating that one or more are
missing (615 for CCM; 616 for DMC; 617 for DPC).
Try another flash drive or if you know this one is OK (it works with a computer), then replace the CCM.
This completes the Advanced Troubleshooting information.