Tweco iCNC XT - Manual (Page 81)

iCNC XT
Manual 0-5299 OPERATION 5-23
5.7.8 Table On/Off/Auto Switch
• ON position will activate the table down draft
• AUTO position will activate the table down draft when a cutting program is active
• OFF position will turn off the table down draft.
5.7.9 Plasma On/Off/Auto Switch
• ON position will activate the plasma. This is used for testing.
• AUTO position will allow the cutting program to command the plasma
• OFF position will prevent activating the plasma.
NOTE:
Some height controllers start the plasma by themselves.