Tweco iCNC XT - Manual (Page 19)

iCNC XT
Manual 0-5299 SPECIFICATIONS 2-3
2.2 Power Requirements
The power connector is located at the backside of the CNC unit. The connector is a standard IEC C14 power connector. Use a IEC C13 plug to
connect the main power to iCNC XT. The power requirement is shown in the product label at the lower left corner in the backside of the CNC.
Use national wiring standards for wire and fuse sizes.
2.3 Mechanical dimensions Yaskawa Motors
SGDV Sigma 5
LL LC
S
See next image
mating dimensions
400W LL = 3.9 in. (98.5mm)
400W LC = 2.36 in. (60mm)
750W LL = 4.5 in. (115mm)
750W LC = 3.15 in. (80mm)
400W S = 0.551 in. (14mm)
750W S = 0.748 in. (19mm)