2 main power, 3 limit switches wiring, 4 e-stop wiring – Tweco iCNC XT User Manual

Page 23: Main power -3, Limit switches wiring -3, E-stop wiring -3, Icnc xt

Text mode
Original mode

iCNC XT

Manual 0-5299

INSTALLATION

3-3

3.2 Main Power

Use a IEC C13 plug to connect the main power to iCNC XT. The main power connector is shown in Section 2.5 Power requirements.

3.3 Limit Switches Wiring

Connect your normally closed limit switches in series as shown in the picture to connector J16 Limits. Y2 alignment switch is used to align the

bridge when homing (optional feature). Mount your Y2 limit so that the bridge is straight when tripping both Y and Y2 limit switches .

3.4 E-stop Wiring

Wire your normally closed E-stop buttons in series to the input. On the power card you have options to enable/disable and change polarity of
the e-stop signals. See next page for jumper descriptions.