Tweco iCNC XT - Manual (Page 48)

iCNC XT
3-28 INSTALLATION Manual 0-5299
3.21 Maximum Speed Test
The next step is 1.6. Max Speed Test. This test is elementary for proper operation of the controller.
CAUTION
Disengage all motors from rails before doing the motion test. Disregarding this may result in mechanical damage.
Make sure the speed potentiometer is set to 100% for this test.
1. Select 1.6. Max Speed Test from iCNC Setup.
2. Put the Drive Enable Switch on the front of the controller to “ON”.
3. Select Start test when you are ready. When all four directions and speeds are set, press the ZERO push button on the controller and set
the Max settable speed for the machine to a slightly slower speed than found in the test.
4. Put the Drive Enable Switch on the front of the controller to “OFF”.
5. Click Ok.