Tweco 42 CutMaster Service Manual - Manual (Page 3)

!
WARNINGS
Read and understand this entire Manual and your employer’s safety practices before installing, operating, or servic-
ing the equipment.
While the information contained in this Manual represents the Manufacturer's best judgement, the Manufacturer
assumes no liability for its use.
Plasma Cutting Power Supply
Cutmaster ® 42
SL40 Torch™
Service Manual l Number 0-5171
Published by:
Thermal Dynamics Corporation
82 Benning Street
West Lebanon, New Hampshire, USA 03784
(603) 298-5711
www.thermal-dynamics.com
Copyright 2011, 2012, 2013, 2014 by
Victor Technologies Incorporation
All rights reserved.
Reproduction of this work, in whole or in part, without written permission of the publisher is prohibited.
The publisher does not assume and hereby disclaims any liability to any party for any loss or damage caused
by any error or omission in this Manual, whether such error results from negligence, accident, or any other
cause.
Publication Date: September 15, 2011
Revision AG Date: March 7, 2014
Record the following information for Warranty purposes:
Where Purchased:_______________________________ ____________
Purchase Date:__________________________________ ____________
Power Supply Serial #:___________________________ _____________
Torch Serial #:___________________________________ ___________
i