Menu index for initial setup, Video output format setup, Progressive / interlace setup – SONIQ DVR150 User Manual

Page 40: Screen saver setup (continued)

Video Output Format Setup

This unit has two video output system: PAL and NTSC. You can select one of them according to

your TV set specs.

Highlight “Video output format” in the general

setup menu and press [ENTER] button. A pop-up

menu will appear.

Select the proper option according to factual requirements.

Press [ENTER] button, then the system will switch the

output format to what you select right now.

You can also switch the TV output format by pressing the

[N/P] button.

Changing the output format may cause no picture on the TV screen. If this happens, you can press

[N/P] button to restore the output format.

Progressive / Interlace Setup

In the general setup menu, use [ ], [ ] buttons to select “Progressive / Interlace”

item and press [ENTER] button, then a list will appear.

Select “Progressive” or “interlace”.

Press [ENTER] button to fulfill the

Progressive / Interlace switch.

Pressing the [I/P] button can proceed

the Progressive / Interlace switch as well.

The value of this setting must Correspond with
the scanning mode of the TV, otherwise the TV
screen will display nothing.
If nothing is shown on the TV screen, you
may try to press the [I/P] button for 5 seconds.
I/P key is only valid in YUV.

Screen Saver Setup (CONTINUED)

Move the cursor up and down to select “ON” or “OFF” by [ ], [ ] buttons.

Press [ENTER] button to turn on or off the screen saver function.

Pressing any button can exit the screen saver mode after the screen saver picture appears.

3
4

SYSTEM SETUP - GENERAL

PAL

Screen saver

Country

Scart output

Video output format

Restore factory settings

progressive/Interace

Interlace
Progressive

Interlace