Powers e420U Series Under-the-Counter Thermostatic Tempering Valves User Manual

Page 4

DIMENSIONAL DATA

CHECKSTOPS

3400 Oakton Street, Skokie, IL 60076 Phone: 800.669.5430 • 847.673.6700 • Fax: 847.673.9044

www.powerscontrols.com

5435 North Service Road, Burlington, Ontario, L7L 5H7 Canada • Phone: 888.208.8927 • Fax: 888.882.1979

WARRANTY INFORMATION

Powers warrants that the equipment manufactured by it is free from defects in material and workmanship and, without charge, equipment
found to be defective in material and workmanship will be repaired, or at Seller’s option, replaced F.O.B. original point of shipment, if writ-
ten notice of failure is received by Seller within one (2) years after date of shipment, provided said equipment has been properly installed,
operated in accordance with Seller’s instructions, and provided such defects are not due to abuse or chemical decomposition by chemical
or galvanic action. This express warranty is in lieu of and excludes all other warranties, guarantees, or representations, express or implied.
There are no implied warranties of merchantability or of fitness for a particular purpose. The Seller assumes no responsibility for repairs
made on Seller’s equipment unless done by Seller’s authorized personnel, or by written authority from the Seller. The Seller makes no guar-
antee with respect to material not manufactured by it.

SERVICING

1. Remove four bonnet screws (16) and pull out bonnet assem-

bly. The motor should come out with the bonnet. If not, it
can easily be pulled out.

2. Remove the cartridge with tool (supplied) and a screwdriver

or pliers.

Before disassembling valve piping, turn off valve and the
supply water upstream.

TIE420U

Page 4

3. Reassemble the valve in reverse order.

4.IMPORTANT: After completing any maintenance/repairs,

check maximum discharge temperature. Adjust if neces-
sary.

Form TIE420U 0218

EDP# 6508935

Printed in U.S.A.