beautypg.com

Troubleshooting, Parts list, Warranty – Powers 720 Series VisuGuard T/P Combination Tempering Valve with LCD Temperature Display User Manual

Page 4

background image

Troubleshooting

n

What to look for if:
• The maximum temperature cannot be obtained:
1) Lime deposits may have accumulated in the hot water pipes,

restricting the hot water supply.

2) The hot water supply temperature may be too low.
3) The temperature limit stop may be set too low. Remove handle

and re-adjust temperature limit stop (refer to step 9 of installation

instruction section).

• Flow of water is less than desired:
1) The upstream supply valves may not be fully open.
2) The inlet supply pressure(s) may be low.
3) The showerhead may be clogged.

• The valve opens with hot water flow rather than cold water flow:
1) The inlet water supplies are connected to the wrong ports or car-

tridge is installed improperly (see section on reversed inlets).

The tempered water is too cold, although cartridge has been replaced,

or the hot water temperature is below 115°F:
1) Raise the temperature of the hot water supply.
Flow of water is completely shut off:
1) The upstream supply valve may be completely closed.
2) The hot or cold water pressure may be failed. The valve is

designed to close down upon cold water supply pressure failure.

3) The checkstops may be closed. Open checkstops by turning the

adjustment screw fully counterclockwise.

Temperature does not display:
1) Replace battery

Parts List

n

Index

Description

Part #

1

Checkstop Kit

900 050

2

Cartridge Kit

220 060

3

Sleeve Kit

220 054

4

LCD Kit

727 013

5

Trim Plate & LCD Kit, Fahrenheit

727 014

6

Trim Plate & LCD Kit, Celsius

727014C

7

Trim Plate Cover

220 076

8

Handle Kit

220 079

1

4

5, 6

7

8

2

3

USA:  Phone: 1.800.669.5430 • Fax 1.847. 229.0526 • www.powerscontrols.com

Canada:  Phone: 1.888.208.8927 • Fax 1

.

888

.

479

.

2887

www.powerscontrols.ca

IS-P-F727_C727 1329

EDP# 6512318

© Powers 2013

Warranty

n

The Seller warrants that the equipment manufactured by it and covered by this order or contract is free from defects in material and workmanship and, without

charge, equipment found to be defective in material or workmanship will be repaired, or at Seller’s option replaced F.O.B. original point of shipment, if written

notice of failure is received by Seller within one (1) year after date of shipment (unless specifically noted elsewhere), provided said equipment has been properly

installed, operated in accordance with the Seller’s instructions, and provided such defects are not due to abuse or decomposition by chemical or galvanic action.

ThiS expreSS warranTy iS in lieu OF and excludeS all OTher warranTieS, guaranTeeS, Or repreSenTaTiOnS, expreSS OF implied. There are

nO implied warranTieS OF merchanTaBiliTy Or OF FiTneSS FOr a parTicular purpOSe. The Seller assumes no responsibility for repairs made on the

Seller’s equipment unless done by the Seller’s authorized personnel, or by written authority from the Seller. The Seller makes no guarantee with respect to material

not manufactured by it.

A Watts Water Technologies Company

WARNING: This product contains chemicals known to the

State of California to cause cancer and birth defects or

other reproductive harm.

For more information: www.watts.com/prop65