Nipros ES-600 Operating Instruction - Manual (Page 27)

27
1
2
HD/Y
HD/B-Y
HD/R-Y
CMP IN
CMP OUT
TALLY IN
MONI IF
DC 12V IN
DC 12VOUT (MAX3.0A)
CAMERA ADAPTOR DS-260
TALLY OUT RET OUT
front panel
MONITOR OUT
(6-pin)
RET OUT
(BNC)
CMP IN
composite
video signal
DC power,and
TALLY signal
リターンコンポジットビデオ信号/
LVM-89Wの接続
Return composite video signal connection with LVM-89W
NIPROS/S26 接続方法
COLOR INPUT RGB MARKER
MONO
16:9
4:3
PEAKING
CAMERA AUDIO OUT EXT LINE (2W I/O) EXT LINE (2W I/O)
HD/SD COMPONENT OUT VIDEO OUT
VIDEO IN AUX
LANC
TC OUT EXT.
AUDIO IN SDI IN OUT 1 OUT 2 OUT 1 OUT 2 SDI RET IN
TC IN RET IN
TALLY EXT LINE (4W I/O)
IN OUT
Y Pb Pr
AC IN
composite
video signal
RET IN
(BNC)
MONI IF
DC 12V IN
DC 12V OUT
(XLR 4-pin)
(DC power)
Connect the RET OUT connector of the camera adaptor and the CMP IN (composite signal input)
connector of the monitor LVM-89W with a BNC cable.
To supply the DC 12V power, connect the MONITOR OUT connector of camera adaptor and the MONITOR
IF connector of the monitor with the supplied 6-pin cable (VC-450).
Or connect the DC 12V OUT connector of the camera adaptor and the DC 12V IN connector of the
the monitor with a XLR 4-pin cable.
リターン画 ( リターンコンポジットビデオ信号 ) を LVM-89W に映す場合は、DS-260 の RET OUT と VM-89W の CMP IN
とを BNC ケーブルで接続します。
電源は、LVM-89W の MONITOR IF コネクタへ DS-260 の MONITOR OUT コネクタから 6 ピンケーブルで接続します。
または LVM-89W の DC 12V IN コネクタへ DS-260 の DC 12V OUT からキャノン 4 ピンケーブルで接続します。
Multi-core Studio System NIPROS/S26
6-
pi
n
ca
bl
e
(V
C-
45
0)
BN
C
ca
bl
e
XL
R
4-
pi
n
ca
bl
e
from
switcher,
etc.
26-p
in ca
ble
DS-560
DS-260
LVM-89W
INTERCOM
HEADSET
EXT.AUDIO OUT
REMOTE DC OUT
AUX
VIDEO IN (VIDEO OUT/TC IN)
Pr IN Pb IN Y IN