Nipros ES-600 Operating Instruction - Manual (Page 21)

21
LVM-89W底部の1/4インチ固定ネジ穴にユニバーサルヘッドをモニター固定ネジで固定します。
Fix the supplied universal head to the screw hole on the bottom surface of LVM-89W with the Monitor
Lock Screw.
Bottom Panel
Monitor Lock Screw
1
2
Universal head
カメラのアクセサリーシューの止まる位置までスライドさせます。シューから抜けないようにシュー固定ねじで固定します。
角度調整固定ねじを緩めてモニターの見やすい位置が決まった後、再度固定ねじを締めます。
Slide the universal head with LVM-89W into the accessory shoe of the camcorder untill the slide-shoe
stops in place. Tighten the Slide-Shoe Lock Knob to fix the universal head with the accessory shoe.
Loosen the Angle Adjustment Knob and adjust the angle of LVM-89W so that the monitor can be watched
well, then tighten the knob again.
Angle Adjustment Knob
Slide-Shoe Lock Knob
Slide-Shoe
2-2 To mount LVM-89W to the camera with the 1/4 inch screw hole(female) install the 1/4 inch male-male
screw adaptor to the bottom of the universal head and screw up to the screw hole of the camera.
Male-male
Screw
Adaptor
Male-male
Screw
Adaptor
1/4インチネジ穴タイプのカメラの場合は、ユニバーサルヘッドの下にオス-オスネジアダプタを取り付けて使用します。
Accessory Shoe
MENU - + FRONT TALLY REAR TALLY
OFF L H OFF L H
REAKING 16:9 MARKER RGB COLOR INPUT
4:3 MONO
MENU - + FRONT TALLY REAR TALLY
OFF L H OFF L H
REAKING 16:9 MARKER RGB COLOR INPUT
4:3 MONO
LVM-89Wモニターの取り付け
Fix the monitor LVM-89W
Multi−core Studio System NIPROS ES−300 & ES−600