E-flite Ultimate 20-300 10 ARF - Manual (Page 7)

7 E-flite Ultimate 20-300 Assembly Manual
Safety, Precautions, and Warnings
As the user of this product, you are solely responsible for
operating it in a manner that does not endanger yourself
and others or result in damage to the product or the property
of others.
Carefully follow the directions and warnings for this and any
optional support equipment (chargers, rechargeable battery
packs, etc.) that you use.
This model is controlled by a radio signal that is subject to
interference from many sources outside your control. This
interference can cause momentary loss of control so it is
necessary to always keep a safe distance in all directions around
your model, as this margin will help to avoid collisions or injury.
• Always operate your model in an open area away from cars,
traffic or people.
• Avoid operating your model in the street where injury or
damage can occur.
• Never operate the model out into the street or populated areas
for any reason.
• Never operate your model with low transmitter batteries.
• Carefully follow the directions and warnings for this and any
optional support equipment (chargers, rechargeable battery
packs, etc.) that you use.
• Keep all chemicals, small parts and anything electrical out of
the reach of children.
• Moisture causes damage to electronics. Avoid water exposure
to all equipment not specifically designed and protected for
this purpose.
Hinging the Ailerons
Required Parts
Top wing Top ailerons (right and left)
Bottom wing Bottom ailerons (right and left)
CA hinge (16)
Required Tools and Adhesives
Felt-tipped pen Straight edge/ruler
Hobby knife Thin CA
Scissors
 1. Use scissors or a hobby knife to cut each hinge away
from the others.
 2. Use a felt-tipped pen to mark the center of four
CA hinges. This will help in positioning them equally
in the aileron and wing.