E-flite Ultimate 20-300 10 ARF - Manual (Page 21)

21 E-flite Ultimate 20-300 Assembly Manual
 9. Use medium CA to glue the tail wheel assembly into
the slot at the bottom of the rudder.
 10. Mark four CA hinges and install them in the slots in
the rudder as shown.
 11. Attach the rudder to the fin using the hinges.
Remember to use a hobby knife to set the gap between
the rudder and fin. Apply thin CA to each side of the
hinges. Make sure to saturate the hinges, applying the
CA to the slot in the hinge so it penetrates fully into the
hinge for the best bond between the rudder and fin.
 12. After CA is fully cured, pull on all surfaces lightly to
make sure that each hinge is fully saturated and bonded.