E-flite Ultimate 20-300 10 ARF - Manual (Page 29)

29 E-flite Ultimate 20-300 Assembly Manual
Upper Wing and Canopy Installation
Required Parts
Fuselage Top wing
Bottom wing Canopy
2mm nut (2) 2mm washer (4)
Interplane strut (2) Machine screw, 2mm x 20mm (8)
Linkage, 7.5-inch (190mm) (2) Machine screw, 2mm x 6mm (2)
Pushrod connector backplate (2)
Lightweight pushrod connector (2)
2mm x 10mm machine screws (2)
Required Tools and Adhesives
Phillips screwdriver: #1 Pin drill
Drill bit: 1/16-inch (1.5mm) Low-tack tape
Adjustable wrench, small Canopy glue
 1. Use canopy glue to attach the canopy. Use
low-tack tape to keep the canopy in position until
the glue has fully cured.
 2. Install the lightweight pushrod connector to the
interconnect horn. It may be necessary to enlarge the
hole in the interconnect horn on the bottom ailerons using
a pin drill and 1/16-inch (1.5mm) drill bit. Repeat for the
other aileron.