E-flite Ultimate 20-300 10 ARF - Manual (Page 31)

31 E-flite Ultimate 20-300 Assembly Manual
 6. With the bottom wing installed, attach the top wing
to the cabane struts using four 2mm washers, two 2mm
nuts and two 2mm x 10mm machine screws. Use a small
adjustable wrench and a #1 Phillips screwdriver to secure
the screws.
 7. Use four 2mm x 20mm machine screws and a #1
Phillips screwdriver to secure the interplane struts to the
top wing as you did on the bottom wing.
 8. After sliding a clevis retainer onto the clevis of the
7.5-inch (190mm) linkage, slide the linkage through the
pushrod connector.
 9. Attach the clevis to the interconnect horn of the top
wing and slide the clevis retainer onto the clevis.