E-flite Ultimate 20-300 10 ARF - Manual (Page 24)

24 E-flite Ultimate 20-300 Assembly Manual
 7. Secure the link using a 2mmx 4mm machine screw
and a #1 Phillips screwdriver.
 8. Repeat Steps 2 through 7 to install the rudder servo
and linkage. The only difference is you will use a 12-inch
(305mm) extension on the rudder servo.
Receiver and Landing Gear Installation
Required Parts
Fuselage assembly Main landing gear (right and left)
Receiver #4 washer, silver (4)
Hook and loop material 6-inch (152mm) servo extension (2)
Socket head screw, 4-40 x 1/2-inch (4)
Required Tools and Adhesives
Ball driver: 3/32-inch Threadlock
 1. Use hook and loop material to install the receiver
inside the fuselage as shown. When installing a remote
receiver, place it as far away from the main receiver as
possible, aligning the antennas perpendicular to those
of the main receiver. You can also install the two 6-inch
(152mm) extensions for the ailerons or a Y-harness if you
are not using a computer radio.