E-flite Ultimate 20-300 10 ARF - Manual (Page 11)

11 E-flite Ultimate 20-300 Assembly Manual
 2. Use a hobby knife to trim the covering from the
slot in the aileron. Leave the covering on the top
for aesthetic purposes. Use medium CA to glue the
interconnect horn in the aileron. Make sure to center
the horn in the aileron before the CA fully cures.
Align horn to aileron centerline
 3. Repeat Step 2 for the top aileron at this time.
 4. Secure a 6-inch (152mm) servo extension to the
aileron servo so it will not unplug inside the wing.
Hint: Use a piece of string or some tape to secure the
two plugs together so that they cannot pull apart inside
the wing.
 5. A string has been placed inside the wing to pull the
servo extension to the center of the wing. Tie this string to
the end of the servo extension as shown.