E-flite Extra 300 32e ARF - Manual (Page 29)

29 E-flite Extra 300 32e ARF Assembly Manual
Battery Installation
Required Parts
Motor battery Fuselage assembly
Hook and loop strap
 1. Use a hook and loop strap (not included) to
secure the battery in the fuselage. The location of
the battery can be adjusted if necessary to achieve
the correct Center of Gravity.
Canopy Installation
Required Parts
Fuselage assembly Canopy hatch
Canopy
Pilot (modelers choice)
Required Tools and Adhesives
Canopy glue Medium grit sandpaper
Felt-tipped pen Clear paper or waxed paper
Low-tack tape Paper towels
Rubbing alcohol
 1. Place a piece of the clear plastic your model
was packed in or a piece of waxed paper over
the fuselage in the area of the canopy hatch. This
will keep you from accidentally gluing the hatch
to the fuselage.
 2. Install the canopy hatch on the fuselage. It may
be necessary to make adjustments to the plastic
or waxed paper to get the hatch pin to lock the
position of the hatch.
 3. Place the canopy on the fuselage. Use a felt-
tipped pen to trace the outline of the canopy on the
canopy hatch. Make sure to center the canopy on
the model before making any marks.
 4. Use medium grit sandpaper to lightly sand
the canopy hatch 1/4-inch (6mm) inside the line
drawn in the previous step.
 5. You may install a pilot of your choice at this time.