E-flite Extra 300 32e ARF - Manual (Page 17)

17 E-flite Extra 300 32e ARF Assembly Manual
 11. Slide the stabilizer tubes in the stabilizer. Use
an epoxy brush to apply a thin layer of epoxy on
the root end of the stabilizer.
 12. Use an epoxy brush to apply a thin layer of
epoxy on the exposed wood of the fuselage at this
time as well.
 13. Slide the stabilizer into position. It must be
pressed tight against the fuselage. Use a paper towel
and rubbing alcohol to remove any excess epoxy.
 14. Apply a small amount of epoxy in the holes
of the stabilizer for the stabilizer tubes in the
remaining stabilizer half.
 15. Use an epoxy brush to apply a thin layer of
epoxy on the root end of the stabilizer. Also apply
epoxy to the exposed wood on the side of the
fuselage as described in Step 12.
 16. Slide the remaining stabilizer into position. It
must be pressed tight against the fuselage. Use a
paper towel and rubbing alcohol to remove any
excess epoxy. Set the fuselage assembly aside until
the epoxy has fully cured.