E-flite Extra 300 32e ARF - Manual (Page 14)

14 E-flite Extra 300 32e ARF Assembly Manual
 2. Place the elevator servo in the fuselage with the
servo output to the rear. With the servo positioned
so it is not touching the sides of the opening, use
a pencil to transfer the locations for the four servo
mounting screws on the fuselage.
 3. Move the servo from the fuselage. Use a pin vise
with a 1/16-inch (1.5mm) drill bit to drill the four
holes in the fuselage for the servo mounting screws.
 4. Place 2–3 drops of thin CA in each of the holes
to harden the surrounding wood. This will help in
preventing the screws from vibrating loose.
 5. Use the four (4) screws provided with the servo
and a #1 Phillips screwdriver to secure the servo in
the fuselage.
 6. Repeat Steps 2 through 5 to install the rudder
servo in the fuselage.
 7. Use hook and loop tape to install the main
receiver and remote receiver in the fuselage. Make
sure to plug the speed control, rudder and elevator
into the appropriate ports of the receiver at this time.