E-flite Extra 300 32e ARF - Manual (Page 13)

13 E-flite Extra 300 32e ARF Assembly Manual
 6. Slide the wheel on the axle. Use a 1.5mm hex
wrench to tighten the wheel collar that secures the
wheel to the axle.
Always use threadlock on metal-to-metal fasteners
to prevent them from vibrating loose.
 7. Slide the wheel pant over the wheel. Position
it so the hole in the landing gear aligns with the
blind nut in the wheel pant. Use a 4-40 x 3/8-inch
socket head screw and #4 washer to secure the
position of the wheel pant. Tighten the screw using
a 3/32-inch hex wrench or ball driver.
 8. Repeat Steps 4 through 7 to install the remaining
wheel and wheel pant.
Fuselage Servo and
Receiver Installation
Required Parts
Fuselage assembly Hook and loop tape
Receiver
Servo with accessories (2)
Servo extension, 18-inch (457mm)
Required Tools and Adhesives
Pencil String
Thin CA Phillips screwdriver: #1
Pin vise Drill bit: 1/16-inch (1.5mm)
 1. Secure a 18-inch (457mm) servo extension to the
elevator servo lead using string or a commercially
available connector. This will keep the servo and
lead from disconnecting inside the fuselage.
Note: You should have already installed the grommets
earlier when you did the aileron servos. If you didn't,
please go back to page 6, Step 4 for instructions.