Watts W100T Twin Alternating Series - Manual (Page 9)

W100T Twin Alternating Series Softeners 9
User 1
Typical user display. If volume is selected in Configuration Settings
Step 4CS, shows volume remaining to regeneration. If volume is not
selected in Configuration Settings Step 4CS, this screen will not be
shown. If a meter is not used this display will not change.
User 2
Displays number of days to next regeneration.
User 3
Displays flow rate in gallons per minute. If a meter is not used this
display will be shown but 0 will be displayed. If 1.0 is selected in
Step 2CS an “A” in front of the flow rate indicates that the tank with
the control valve on it is in service. If “b” is displayed the tank with the
in/out head is in service.
This screen will not be shown if 7 day or 28 day is selected in
Configuration Settings Step 4CS.
User 4
Displays total flow in gallons since last reset. If a meter is not used this
display will be shown but 0 will be displayed. This screen will not be
shown if 7 day or 28 day is selected in Configuration Settings Step
4CS.
PRESS ▼ FOR 3 SECONDS TO RESET TO 0.
User 5
Shows current time.
B. Setting Time of Day
• Push NEXT until time of day screen is displayed. Press and
hold ▲or ▼ until the SET indicator is displayed, and the hour
flashes. Press ▲or ▼until the correct hour is displayed.
• Then press NEXT. The minutes will flash. Press ▲or ▼until
the correct minute is displayed.
• Press NEXT to return to the Display Screens. Time of day
should only need to be set after power outages lasting more
than 8 hours, if the battery has been depleted and a power
outage occurs, or when daylight saving time begins or ends.
If a power outage lasting more than 8 hours occurs, the time
of day will flash on and off which indicates the time of day
should be reset. If a power outage lasts less than 8 hours
and the time of day flashes on and off, the time of day should
be reset and the battery replaced.
User Displays
A. General Operation
When the system is operating, one of five displays may be shown. Pressing
NEXT will alternate between the displays shown below.