Watts W100T Twin Alternating Series - Manual (Page 14)

14 W100T Twin Alternating Series Softeners
Setting Regeneration Cycle Times
Step 1CT
Press NEXT and ▼ simultaneously for 5 seconds and release. If screen in Step
2CT does not appear, the lock on the valve is activated. To unlock press ▼, NEXT,
REGEN, ▲ in sequence, then press NEXT and ▼ simultaneously for 5 seconds and
release.
Step 3CT
Adjust the length of the backwash from 1-95 minutes using
▲or ▼.
Press NEXT to go to Step 4CT. Press REGEN to return to previous step.
Step 4CT
Adjust the length of the regenerant draw from 1-180 minutes using ▲or ▼.
Press NEXT to go to Step 5CT. Press REGEN to return to previous step.
Step 5CT
Adjust the length of the second backwash from 1-95 minutes using ▲or ▼.
Press NEXT to go to Step 6CT. Press REGEN to return to previous step.
Step 6CT
Adjust the length of rinse from 1-95 minutes using ▲or ▼.
Press NEXT to go to Step 7CT. Press REGEN to return to previous step.
Step 7CT
Adjust the length of fill from 0.1-99.0 minutes or OFF. CWS200 valves are shipped
from the factory with a refill flow control of 2.2 gpm (8.3 lpm). All other control valves
are shipped from the factory with a refill flow control of 0.5 gpm (1.9 lpm).
Press NEXT to exit Regeneration Cycle Times. Press REGEN to return to previous
step.
Step 2CT
Select between SOFTENING or FILTERING.
When set to FLTr, only Steps 3CT and 6CT are available.
Press NEXT to go to Step 3CT. Press REGEN to exit Regeneration Cycle Times.
Step 1CT
Step 3 CT
Step 4 CT
Step 5 CT
EXIT TO
DISPLAY
SCREENS
Step 7 CT
Step 6 CT
Step 1CT
Step 3 CT
Step 4 CT
Step 5 CT
EXIT TO
DISPLAY
SCREENS
Step 7 CT
Step 6 CT
Flow
Rate
AM
Time
Set
Volume
X1000
Regen
Backwash
Brine
Rinse
Fill
PM Days To
Regen
Step 2CT
Step 1CS
Step 2CS
Step 3CS
Step 4CS
Step 5CS
EXIT TO
DISPLAY
SCREENS