Watts Autotrol 263 / 268 (Logix Series) - Manual (Page 39)

PLACING CONDITIONER INTO OPERATION (turning on the water) 39
Rev A
Things You Might Need to Know
• When the controller is first plugged in, it may display a flashing
hourglass and the message Err 3, this means that the controller is
rotating to the home position. If the Err 2 is displayed, check that the
incoming power frequency matches the controller. The North
American controller will not run with 50 Hz input.
• The preset default time of regeneration is 2:00 AM.
• English or Metric? The World controller senses the electrical input and
decides which is needed. The North American controller only runs on
60 Hz and defaults to English units.
• The 700 Series controller can be programmed to regenerate on
specific days of the week.
• If electrical power is not available, the camshaft can be rotated
counterclockwise by hand if the motor is removed.
• The 700 Series controllers send commands to the motor for camshaft
movement. However, water pressure/flow are required during the
regeneration cycle for backwash, purge and refill, and brine draw to
actually take place.
• Make sure control power source is plugged in. The transformer should
be connected to a non-switched power source.
• You can start programming at the beginning by resetting the amount
of media. When viewing H0 (History Value) push and hold SET for five
seconds. The display reverts back to
--- and any programmed
information is lost. Return to 700 Series Initial Power Up.