Watts Autotrol 263 / 268 (Logix Series) - Manual (Page 29)

DISPLAY ICONS 700 CONTROLLER 29
Rev A
13. The display cursor is next to "SALT" when programming the amount of
regenerant. If the controller is on a 3-cycle filter then backwash time is
programmed.
14. The display cursor is next to "REGEN TIME & DAY" when programming
the time of regeneration and the days of regeneration.
15. The display cursor is next to "TIME & DAY" when programming the
current time and day.
16. The hourglass is displayed when the motor is running. The camshaft
should be turning.
17. These cursors will appear next to the item that is currently displayed.
18. X100 multiplier for large values.
19. Shows when water is flowing through the valve.
20. Used with #24, #25, and #26. Displays a sequence number or a value.
21. History Values (H). The number displayed by #23 identifies which
history value is currently displayed.
22. Parameter (P). Displayed only in Level II Programming. The number
displayed by #23 identifies which parameter is currently displayed.
23. Cycle(C). The number displayed by #23 is the current cycle in the
regeneration sequence.
24. Hardness setting—only used with 760 and 760C controllers.
25. Capacity display—shows estimated system capacity.