Metrohm 850 Professional IC Anion MSM-HC - LP-Gradient - Manual (Page 5)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
Table of contents
850 Professional IC Anion MSM-HC LP Gradient
￭￭￭￭￭￭￭￭ III
Table of contents
1 Introduction 1
1.1 Instrument description ......................................................... 1
1.2 Intended use ......................................................................... 3
1.3 About the documentation ................................................... 3
1.3.1 Symbols and conventions ........................................................ 3
1.4 Safety instructions ................................................................ 4
1.4.1 General notes on safety ........................................................... 4
1.4.2 Electrical safety ........................................................................ 4
1.4.3 Tubing and capillary connections ............................................. 5
1.4.4 Flammable solvents and chemicals ........................................... 6
1.4.5 Recycling and disposal ............................................................. 6
2 Overview of the instrument 7
2.1 Front ...................................................................................... 7
2.2 Rear ........................................................................................ 9
3 Installation 12
3.1 About this chapter .............................................................. 12
3.2 Initial installation ................................................................ 12
3.3 Installation of the low pressure gradient ......................... 15
3.4 Installation diagram .......................................................... 16
3.5 Setting up the instrument .................................................. 18
3.5.1 Packaging .............................................................................. 18
3.5.2 Checks .................................................................................. 18
3.5.3 Location ................................................................................ 18
3.6 Capillary connections in the IC system ............................. 18
3.7 Rear of the instrument ....................................................... 20
3.7.1 Rollers and handle ................................................................. 20
3.7.2 Positioning and connecting the detector ................................ 23
3.7.3 Transport locking screws ....................................................... 23
3.7.4 Leak sensor ........................................................................... 23
3.7.5 Drainage tubings ................................................................... 24
3.8 Capillary and cable feed-throughs .................................... 26
3.9 Eluent ................................................................................... 29
3.9.1 Connecting eluent bottle ....................................................... 29
3.10 Eluent degasser ................................................................. 33
3.11 Low pressure gradient ....................................................... 35