Metrohm 863 Compact Autosampler - Manual (Page 71)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 10 Appendix
863 Compact Autosampler ￭￭￭￭￭￭￭￭ 61
Outputs
Open Collector
tp
t
p
＞ 200 ms
active = low, inactive = high
I
C
= 20 mA, V
CEO
= 40 V
+5 V: maximum load = 20 mA
10.1.2 Status diagram of the remote interface
[START]
Output 0
Output 1
Output 2
Output 3
Output 4
Ready
Error
Start/Continue
Stop
Input 0
Input 1
[STOP]
Figure 18 Remote status diagram
10.2 USB devices
Note
USB peripheral devices that are to be connected directly must support
the USB 1.0/1.1 (Full Speed) or USB 2.0 (High Speed) standard. The
maximum data transfer rate is however in any case 12 MBit/s.
Keyboards, PC mice and barcode readers are so-called HID devices
(Human Interface Device) and can be connected via a USB hub only.
Printers should also be connected via a USB hub. Depending on the
manufacturer or printer type a direct connection is however possible.