Metrohm 882 Compact IC plus – Anion - Manual (Page 59)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 3 Installation
882 Compact IC plus – Anion ￭￭￭￭￭￭￭￭ 49
2 Rinsing the separation column
￭ Place beaker under the outlet end of the separation column.
￭ Set the flow rate of the high pressure pump according to the data
given in the leaflet of the separation column.
￭ Start the high pressure pump and rinse the separation column
approx. 10 minutes with eluent.
￭ Switch off the high pressure pump again.
3 Mounting the separation column
￭ Fasten the column output capillary to the output of the separation
column using a PEEK pressure screw (6.2744.070).
￭ Hang separation column with chip into the column holder.
Note
The iColumns are equipped with a chip on which their operating data is
saved. The chip has to be hooked into the chip holder provided for this
so that the column recognition can function.