Equipment/lashers, pullers, positioners and guides – CommScope Trunk & Distribution Cable User Manual
Page 69
Cable Lasher
Used to lash cable
directly to installed
strand or cable
bundles. Lashers are
somewhat specific to
cable and strand size
- improper lasher size or
adjustment may damage
cables.
Multiple Cable Puller
Allows multiple cables to be pulled into place
when lashing
cables directly
to strand. It’s
equipped with a
strand brake to
prevent sagging of cables as the pulling tension
is released. Allows pulled cables to indepen-
dently swivel.
Overlash Cable Puller
Allows multiple cables to be pulled into place in
overlash applications.
Allows pulled cables
to independently
swivel.
Equipment/Lashers, Pullers, Positioners and Guides
Cable Block Pusher (or Shotgun or Shuttle)
Used to push equipment ahead of a pulled lasher.
Cable Positioner (or Magic Box)
Pushed in front of a lasher
by a cable block pusher
to uniformly position mul-
tiple cables that are being
lashed.
Cable Guide
Used to guide the cable into the lasher in drive-off
applications. Can be used for new strand or overlash
applications. The guide may
be pushed in front of the
lasher with a cable block
pusher, pulled in front of the
lasher or physically attached
to the lasher, dependent on
the cable guide type.
Appendix 8.10
Equipment/Lashers, Pullers, Positioners and Guides