CommScope Trunk & Distribution Cable - Manual (Page 56)

P3 ® Connectorization
Use the right tools: a P3 coring tool, a P3 jacket stripper, a file, center conductor cleaning tool, wrenches
sized for the connectors (adjustable wrenches are fine) and cable cutters. A hi-torque, low-speed drill or a ratchet
are optional, but will speed the process. Wearing safety glasses and gloves are recommended.
Prepare the cable by using the cable cutters to trim the cable to a smooth, round end.
Remove the jacket using a P3 jacket removal tool. This tool rotates around the cable and removes jacket
material without scoring the aluminum. A knife is not recommended for this process.
Remove any MigraHeal ® compound that may be on the shield.
Remove the proper amount of shield and dielectric with the P3 coring tool. Slide the cable into the
tool until it stops. With slight forward pressure, twist the coring tool (either by hand or mechanically with the
ratchet or drill) so that the blade begins to strip and core the cable. Continue to turn the coring tool until the
proper trim dimensions are achieved. Clean the dielectric and shield residue from the tool.
Clean the center conductor by using a non-metallic cleaning tool. Score the coating on the center
conductor at the shield and scrape it toward the end of the conductor. The conductor is clean if the copper is
bright and shiny. DO NOT USE A KNIFE or other metal tool as it may damage the copper cladding.
Slide the shrink tubing (highly recommended) over the cable end, then attach the
connector according to the manufacturer’s instructions. Place and shrink the boot. Note: if you are using a
heat-shrink boot, apply the flame carefully. Overuse of the torch may melt the jacket and dielectric.
6.7 Connectorization
Overview of P3 Connectorization