beautypg.com

Underground installation of commscope cable – CommScope Trunk & Distribution Cable User Manual

Page 42

background image

Underground Installation of CommScope Cable

There are several cable types built specifically for underground installation:

QR/P3 JCASS/MOCJ with Migra-Heal

®

flooding compound between the shield and jacket

QR 2J(MA)CASS

with twin polyethylene jackets separated by a tough polypropylene tape for extra

resistance to cut-through

P3 CableGuard

®

with crush resistant air pockets built in

QR/P3 JACASS/MOCG with twin polyethylene jackets separated by corrugated chrome plated steel armor

ConQuest

®

CommScope cable pre-installed in a tough high-density polyethylene conduit for

Cable-in-Conduit

direct burial. Please consult our Conduit Applications and Construction

Manual.

The three methods for direct burial are vibratory plowing, trenching and boring.

Vibratory Plowing is the most popular method. A plow with a special blade slices

through the ground. The cable runs through a tube in the blade and is placed as the

plow moves forward. Since no dirt is displaced, vibratory plowing is much less intrusive

than trenching.

Trenching involves digging or plowing a trench, placing the cable in it and then

burying it.

Boring (directional and conventional) digs or punches a hole in the earth, usually from

one trench to another. It is an excellent method for crossing areas that cannot be plowed (such as paved roads or

railroad tracks) if they cannot be traversed aerially. Cable is then pulled through the hole.

CommScope cable may also be pulled through existing underground conduit or ductwork. As with

aerial installation, careful attention must be paid to not exceeding the maximum pulling force or the minimum

bend radius.

QR pulls

through

ducts with

less effort

than any

other

coaxial

cable

5.1

Underground Installation

Overview