Moving reel method – CommScope Trunk & Distribution Cable User Manual
Page 33
Moving Reel Method
The moving reel method of placing
self-supporting cable is used where
a cable reel can be moved along
side the pole line and there are no
obstructions to prevent the cable
from being raised into position.
Loading the Cable Reel
Load the cable reel so the cable is payed-out from the top of the reel. Use one of the blocks and frames pictured
on page 4.3 for this placement method. If trees or other obstructions restrict the use of this method for a few
sections close to either end of the run, proceed as follows. Pull the cable beyond
the obstruction and lift into place. Resume the moving reel method once the
obstruction is cleared. Where it is necessary to clear street or driveways use a
Strand Puller attached to the pole with a sling. Do not remove the strand puller until
the cable has been pulled to final sag at the dead ends or tensioning locations.
Note: The cable and strand must be separated before using a strand puller to
prevent damage to the cable. A strand dead end or wire vise may be used to pull
IM cable with.
Caution: Do not use J Hooks to place IM cable. Coaxial cable should never be pulled over placing hooks.
Placing the Cable in Blocks
If a bucket truck is not available, the cable should be raised into place using a cable-lifting tool.
Do not tension cable around cable blocks. Tension should only be applied from corner poles outward.
reel pays off
over the top
cable is lifted
into place on
the block
pole mount
block supports
the cable
the cable is
attached by the
messenger to
the pole
Integrated Messenger Installation
4.4
Moving Reel Method