beautypg.com

Bending radii – CommScope Trunk & Distribution Cable User Manual

Page 44

background image

Bending Radii

Cables are often routed around corners during cable placement and pulling tension

must be increased to apply adequate force to the cable to bend the cable around

the corner. Tension is directly related to the flexibility of cable - and flexibility is QR’s

greatest strength.

CommScope’s specified minimum bending radius is the static (unloaded) bending

radius of the cable. This is the minimum radius to which the cable can be bent

without electrically or mechanically degrading the performance of the cable. Bending

the cable in this manner is usually only done during splicing or final forming. This is

also the radius allowed for storage.

Always review the specifications for the appropriate

bend radii. If you do not exceed the minimum bend

radius nor exceed the maximum pulling tension, you

should have a successful installation.

The bending radii of cables

during the construction process

are controlled by the radii of the

bends in duct or conduit as well

as construction techniques and

equipment.

QR’s shield

construction

permits the

tightest bend

radius in the

industry

Minimum

Cable

Bending Radii

in/cm

QR 320

3 (7.6)

QR 540

4 (10.2)

QR 540 armored

6.5 (16.5)

QR 715

5 (12.7)

QR 715 armored

7.5 (19.1)

QR 860

7 (17.8)

QR 860 armored

9.5 (24.1)

P3 500 standard (jacketed)

6.0 (15.2)

P3 500 bonded (jacketed)

3.5 (8.9)

P3 625 standard (jacketed)

7.0 (17.8)

P3 625 bonded (jacketed)

4.5 (11.4)

P3 750 standard (jacketed)

8.0 (20.3)

P3 750 bonded (jacketed)

6.0 (15.2)

P3 875 standard (jacketed)

9.0 (22.9)

P3 875 bonded (jacketed)

7.0 (17.8)

MO500

6.0 (15.2)

MO650

7.0 (17.8)

MO750

8.0 (20.3)

5.3

Underground Installation

Bending Radii