Equipment/blocks, chutes and brackets – CommScope Trunk & Distribution Cable User Manual
Page 68
Equipment/Blocks, Chutes and Brackets
90° Corner Block
Used to route cables through inside or outside corners up to 90°.
It minimizes drag on the cable in corners and ensures that the
minimum bend radius of the cable is not exceeded. Requires
specialized mounting hardware depending on the specific use of
the equipment.
45° Corner Block
Used to route cables through inside or outside corners up to 45°.
It minimizes drag on the cable in corners and ensures that the
minimum bend radius of the cable is not exceeded. 45° corner
blocks may be used as a set-up chute to guide cables from the
cable trailer or a reel stand. Requires specialized mounting
hardware depending on the specific use of the equipment.
Set-Up Chute
A set-up chute is used to guide cables from the cable trailer or
reel stand. This equipment requires specialized mounting
hardware depending on the specific use of the equipment.
Set-Up Bracket
This bracket is used to support 45°
and 90° corner blocks or set-up chutes
at mid-span.
8.9 Appendix
Equipment/Blocks, Chutes and Brackets