beautypg.com

Adding additional hardware after commissioning, Adjusting motion sensor sensitivity – CommScope Redwood version 3.2 User Manual

Page 16

background image

Commissioning and Administration User Guide

13

Adding Additional Hardware After Commissioning

You can add Fixtures at any time after the initial configuration is complete. When detected,

they are automatically placed in the Unassigned group. You can add Fixtureless Gateways to

the same Locations as LEDs and fluorescents. They do not participate in light-control features

nor limit the functionality for a Location.

To add a Fixture or switch:

1. In the Location Editor tab, select the Location.
2. Drag the Fixtures you want to add to the Location.
3. To save this configuration change, click Apply at the bottom left of the screen.

IMPORTANT NOTE

Fixtureless Gateways can be added to the same Locations as LEDs and Fluorescents. They

will not participate in any light control related features, nor limit the functionality listed under

lighting control for a Location.

Adjusting Motion Sensor Sensitivity

You can disable the motion sensor or set the sensitivity level. Disabling the sensor causes the

Fixture’s Location to ignore the Sensor’s motion data.

To set motion sensor sensitivity:

1. In the Maintenance tab, click the Location on the left and select the Fixture in the middle

pane.

2. From the drop-down menu in the right pane, select Configuration. The Sensor model is

listed under Sensor Type.

3. Under Sensitivity, select the sensitivity level from the drop-down menu. The Sensor type

determines the sensitivity levels presented.

4. Click Apply.