Assigning fixtures to locations – CommScope Redwood version 3.2 User Manual
Page 12
Commissioning and Administration User Guide
9
Assigning Fixtures to Locations
After creating Locations, you can assign Fixtures and Wall Switches to their appropriate
Locations. The number next to each Location indicates the number of Fixtures within that
Location.
Newly discovered Fixtures and Wall Switches are automatically placed in the Unassigned
Location. If a Sensor is unassigned, the Sensor’s LED indicator light will be solid red. If a Wall
Switch is unassigned, the Wall Switch’s LED indicator light will be solid green.
You can assign Fixtures and Switches to any Location in the hierarchical tree, except directly
under “All Locations,” with the simple drag-and-drop interface.
IMPORTANT NOTE
The Universal Gateway – Outage Relay provides information about the status of the
Redwood Engine system. You cannot move it out of the Unassigned Location as it
does not require commissioning.
As illustrated in the diagram above, the Universal Gateway – Outage Relay is also
visible from within the Location Editor. Please see the Installation Instructions for more
information on the Universal Gateway – Outage Relay.