beautypg.com

CommScope Redwood version 3.2 User Manual

Page 14

background image

Commissioning and Administration User Guide

11

6. Click the Start Flashlight Commissioning button.
!

A Location named Commissioned is automatically created under the Flashlight Location.

!

The Fixtures in the Flashlight Location will dim, and their Sensor’s LED starts flashing red.

!

Note: With flashlight commissioning sensor-only installations, the Sensor LED indicator

light turns red, but since there is no Fixture, nothing will turn on. Likewise, for Wall

Switches, and green LED indicator light is used when flashlight naming.

7. Shine the flashlight on the Fixtures in the desired order.
!

When a Fixture is commissioned, it is renamed according to the naming scheme and

moved to the Commissioned Location.

!

Its Sensor will stop blinking, and will show solid red.

!

The Fixture will be set to 100% light level.

!

Note: To skip a sequence number while commissioning, click the Skip button.

!

Note: Click the Cancel button to stop the flashlight commissioning process and undo all

flashlight naming completed up to this point.

8. Click Done to exit the flashlight commissioning process. The Sensors’ LEDs turn off.
9. Drag the newly renamed Fixtures from the Commissioned Location into their appropriate

Location based on the lighting plan.

10. To save this configuration change, click Apply, at the bottom left of the screen.

LED Status

Port Status

Off

The Sensor or Wall Switch is not ready for

commissioning. The possible explanations are:

"#$%&#'(&)!*+,,'%%'+-'-(!&$%!-+)!./)!0//-!

'-')'$)/12!

3&/!4/-%+5!'-!67/%)'+-!'%!-+)!'-!)&/!89#$%&#'(&)8!

:+*$)'+-2!

Flashing Red/Green

The Sensor or Wall Switch is ready for

commissioning and has not yet been named.

Solid Red/Green

The Sensor or Wall Switch has been successfully

named.

Using Blink to Name Fixtures

Blinking makes it easy to identify Fixtures in the building.

1. In the Location Editor tab, highlight the Fixture. To select multiple Fixtures, press the Shift

key while selecting additional Fixtures.

2. On the right, click the Blink button to make the Fixture flash.
3. After you identify the Fixture, click the Blink button again to stop the blinking.
4. Use the button to rename the Fixture.
5. Drag and drop the Fixtures and Switches to their Locations.
6. To save this configuration change, click Apply, at the bottom left of the screen.