Brother NC-4100H - Manual (Page 89)

CHAPTER 7 APPLETALK (ETHERTALK) TCP/IP PRINTING
7-3
Operation
Once the print server is installed and the printer is powered on, the Brother print
server AppleTalk service name (default is BRN_xxxxxx_P1_AT, where "xxxxxx" is
the last six digits of the Ethernet address (MAC address) should appear in the
Chooser. If you have an NC-2000 series print server such as the NC-2100h or NC-
2010h, the default Chooser name will be BRO_xxxxxx_P1_AT
You can find the service name and MAC address by printing out the printer
configuration page. Refer to the Quick Setup Guide for information on how to print
the configuration page on your print server.
How to Select the Print Server
(AppleTalk/EtherTalk)
1. Open the Chooser from the Apple Menu on the Macintosh, and then click on
the LaserWriter icon (if necessary, select the appropriate AppleTalk zone
from the Network Control Panel).
Figure 2 Macintosh Chooser
2. Click on the appropriate print server and close the Chooser program. You
should now be able to print from the Macintosh.
If you cannot see the print server, first make sure that your cabling is correct and that
you have enabled EtherTalk from your Macintosh Network Control Panel. You may
also need to force the print server into the correct AppleTalk zone using the
BRAdmin application or a web browser.