Standard tcp/ip port printing, Standard tcp/ip port printing 2-3 – Brother NC-4100H User Manual
Page 31
CHAPTER 2 TCP/IP PRINTING
2-3
Windows 2000 Printing
(Printer Driver not yet installed)
By default, Windows 2000 systems install with all the necessary software required
for you to be able to print. This chapter describes the two most commonly used
configurations, Standard TCP/IP Port printing and IPP (Internet Printing Protocol). If
you have already installed the printer driver, jump to the printer driver already
installed section.
Standard TCP/IP Port Printing
1.
From the Printers Folder select "Add Printer", the "Add Printer Wizard" will
now start. Click on "Next".
2.
Now select the Local Printer option and deselect the "Automatically detect
and install my Plug and Play printer" option.
3.
Click on "Next".
4.
You must now select the correct Network printing port. Select the "Standard
TCP/IP Port" option as the port is installed by default on Windows 2000
systems.
5.
When you have done that click "Next".
6.
The "Add Standard TCP/IP Port Wizard" will now appear. Click the "Next"
button.
7.
Enter the IP address, or name of the printer you wish to configure. The
Wizard will automatically enter the Port name information for you.
8.
Click the "Next" button.
9.
Windows 2000 will now contact the printer that you specified. If you did not
specify the correct IP address or name then you will receive an error
message.
10.
Click the "Finish" button to complete the Wizard.
11.
Now that you have configured the port, you must specify which printer
driver you wish to use. Select the appropriate driver from the list of
supported printers. If you are using a driver supplied with the printer on CD-
ROM/Floppy then select the "Have Disk" option to browse to the CD-
ROM/Floppy disk. You can also click the “Windows Update” button to
connect directly to Microsoft’s support Web site to download printer drivers.
12.
When the driver is installed, click the Next button.
13.
Specify a name and click the “Next” button.
14.
Now specify if you wish to share the printer, enter the share name and click
“Next”.
15.
Continue through the Wizard clicking the “Finish” button when complete.