Brother NC-4100H - Manual (Page 102)

CHAPTER 9 LAT NETWORK CONFIGURATION
9-3
VMS LAT Host Configuration
The configuration process requires that you have system manager privileges. Before
starting the LAT configuration process, you must first make sure that LAT has been
started on your system. If you are currently using terminal servers on your network,
then LAT has probably already been activated. If LAT is not started, you need to
execute the following command before proceeding:
@SYS$STARTUP:LAT$STARTUP
1. Before creating a print queue, you will need to determine the following:
•
The VMS queue name. This can be any unique name. (Do a SHOW
QUEUE command at the VMS prompt to list the existing queues).
•
The LAT application port. The name of this port is LTAxxx, where
"xxx" is any unused number (do a SHOW PORT command in the VMS
LATCP program to see the existing ports).
•
The print server node name and port name . The default node name
is BRN_xxxxxx, or BRO_xxxxxx where "xxxxxx" is the last six digits
of the MAC address (Ethernet address), for example, BRN_310107).
You can see the name of your print server by printing out a
configuration page:
You can find the node name and MAC address by printing out the printer
configuration page. Refer to the Quick Setup Guide for information on how to print
the configuration page on your print server.
If you wish to use a different node name, use the BRAdmin application or a web
browser to change the name.