Brother NC-4100H - Manual (Page 133)

CHAPTER 12 TCP/IP CONFIGURATION
12-11
On a NetWare networks, you can use the BRCONFIG utility which are included with
every print server.
If you are using the remote console, you will get the message Console connected
(VMS) or Connection established (BRCONFIG) or Remote console reserved
(ULTRIX). Press RETURN and enter the default password "access" in response to
the "#" prompt (it will not echo).
You will be prompted for a user name. Enter anything in response to this prompt.
You will then get the Local> prompt. Type SET IP ADDRESS ipaddress, where
ipaddress is the desired IP address you wish to assign to the print server (check with
your network manager for the IP address to use). For example:
Local> SET IP ADDRESS 192.189.207.3
You will now need to set the subnet mask by typing SET IP SUBNET subnet mask,
where subnet mask is the desired subnet mask you wish to assign to the print server
(check with your network manager for the subnet mask to use). For example:
Local> SET IP SUBNET 255.255.255.0
If you do not have any subnets, use one of the following default subnet masks:
255.255.255.0 for class C networks
255.255.0.0
for class B networks
255.0.0.0 for class A networks