Calculated Industries 4065 v3.1 User Guide User Manual
Page 94
86 — C
ONSTRUCTION
M
ASTER
®
P
RO
/ T
RIG
/ D
ESKTOP
How to Set Preferences
The following sections detail Preference Setting options for the
Construction Master Pro
calculators.
Enter the Preference Mode by pressing
З Я
(Prefs)
. Access
each category by pressing the
ß
key until you reach the desired
setting. Within each category, press the
+
or
–
keys to toggle
between individual selections. Press
o
to exit and set your
Preference.
Note: Press
+
to advance and press
–
to back up. Pressing the
ß
key continuously
in this mode will cycle through all of the Preference Settings.
You may change these settings at any time by repeating the above,
and setting in a new preference.
To reset preferences back to factory default settings, turn your calcu-
lator off, hold down the
x
key and turn the calculator back on.
For example, if you wish to display all your dimensional area answers
in square meters, press
З Я Я
(Area Std)
, then the
+
key
until “AREA 0.
SQ M
” is displayed. Simply exit this mode by pressing
o
or any key, except
+
or
ß
,
and all your future area answers
will be displayed in square meters.
Accessing Preference Settings
KEYSTROKE
DISPLAY
To Set “Fractional Resolution”:
З Я
(Prefs) (1st press of
ß
)
FRAC 0-1/16
INCH
+
(plus sign)
FRAC 0-1/32
INCH
+
FRAC 0-1/64
INCH
+
FRAC 0-1/2
INCH
+
FRAC 0-1/4
INCH
+
FRAC 0-1/8
INCH
+
(repeats options)
FRAC 0-1/16
INCH
To Set “Area” Answer Format:
ß
(2nd press of
ß
)
AREA Std.
+
(plus sign)
AREA 0.
SQ FEET
+
AREA 0.
SQ YD
+
AREA 0.
SQ M
+
(repeats options)
AREA Std.
(Cont’d)