Calculated Industries 4065 v3.1 User Guide - Manual (Page 93)

U
SER
’
S
G
UIDE
— 85
(Cont’d)
PREFERENCE OPTIONS
8) Irregular Jack Rafters – *OC-OC (On-center spacing maintained
O-C or Mate on both regular and irregular sides)
– JAC-JAC (regular/irregular Jack rafters
“mate” at the hip/valley, e.g., On-center
spacing not maintained on both sides)
9) Exponent Off or On – *Off (Exponential Mode is Off; turns
on Auto-ranging; e.g., if display can’t
show seven digits, will display in next
largest unit).
– On (Exponential Mode is On)
10) Meter Linear Display – *0.000 (linear Meter answers are
always displayed to third decimal place)
– FLOAt (linear Meter answers are
displayed to the maximum number of
decimal places — e.g., 1.234 M + 2.56 M
= 3.794 M)
11) Decimal Degree – *0.00°
Display – FLOAt
12) Fractional Mode – *Standard (fractions are displayed to
the nearest fraction)
– Constant (fractions are displayed in
the set fractional resolution)